Step 1 - use a plate about 10 cm in diameter to draw a circle cardboard.
Step 2 - cut the circle.
Step 3 - Make a line from the edge to the center and cut it out. So you can build a cone, which is fixed with heat so it does not disarm, and may be the front of the rocket. Is set to heat at the end of the long tube.
Step 4 - cardboard cut three cusps, which are five tabs on the sides, to be easier to hold the short tubes.
(Step 5) - we did not. Is to make a mixture of glue and water in equal parts, and wet in her paper towel or newspaper to be sticking it to all the rocket and provide consistency.
Step 6 - Paste the small tubes, with their wings already in place, the large tube.
Step 7 - decorate as desired.
0 comments:
Post a Comment